Sled Puller
May 7th, 2009, 09:43 AM
This beast has a flat head 6 Continental. Just had the carb professionally rebuilt, runs great. Needs a muffler and exhaust, and some plastic lever handles.
It has about 9 feet of reach, not sure of its capacity or what it weighs. Knowing what my trailer and truck acts like hauling an 8000# pulling truck, I would assume somewhat heavier than that.
It also is set up to rotate the forks, but needs hoses to run that system.
Its worked fine around here for several years, replaced it with a skid loader.
$1500.00 or best offer.
NW PA.
It has about 9 feet of reach, not sure of its capacity or what it weighs. Knowing what my trailer and truck acts like hauling an 8000# pulling truck, I would assume somewhat heavier than that.
It also is set up to rotate the forks, but needs hoses to run that system.
Its worked fine around here for several years, replaced it with a skid loader.
$1500.00 or best offer.
NW PA.